Drying timber in a solar kiln using an intermittent drying schedule of conventional laboratory kiln

The purpose of this study was to apply an intermittent drying schedule developed from a conventional kiln to a solar kiln. Implementing this experiment could help better understand the oscillation of the temperature inside a solar kiln and timber quality during drying progress. The theoretical recharge and discharge curves were used to predict the temperature inside the solar kiln using experimental data obtained previously using a solar kiln. The surface and internal checks were measured using ImageJ freeware, and the development of the Moisture Content (MC) profile was assessed by coring and slicing method for the Eucalyptus delegatensis boards during drying. The results showed that the recharge and discharge model can predict the temperature with less than 2 degrees C error from the experimental data in the solar kiln. The total drying time to 12% MC was 87 days for the solar kiln. The drying rate was equivalent to the conventional kiln decreasing at an average rate of 0.2% per day. The surface check formation was found when the MC gradient between the core and the case of the board was greater than 42% at 9 days of drying in the solar kiln and conventional laboratory kiln. The applied drying schedule used in the solar kiln was successful and offered similar drying time. However, the oscillation of temperature in the intermittent drying will require further improvement to get closer conditions in a solar kiln.