Preparation and characterization of novel low-cost sensible heat storage materials with steel slag

Heat storage temperature, heat storage density, heat storage stability and the cost of heat storage are the breakthroughs for further development of heat storage materials. In this study, a new type of sensible heat storage material was prepared by using low-cost steel slag as the main component, and at the same time, an effective way of recycling steel slag was provided. The stabilizable shaped steel slag powder was obtained by high temperature pretreatment, and the optimal high temperature pretreatment temperature was found to be 850 degrees C. Through the analysis of the effects of different pretreatment steel slag content and different sintering temperatures on the organization and properties of heat storage materials, it was found that a large number of elemental migration and oxide solid solution phenomena occur during the sintering process, and the melting of low melting point solid solution occurs during the high temperature treatment process. The steel slag heat storage material has the best performance when the content of pretreated steel slag is 60 wt% and the sintering temperature is 1200 degrees C. Its compressive strength is stabilized at about 80 MPa, thermal conductivity is 1.13 W/ (m center dot K), and thermal density is 1222.168 J/g in the range of 50-1000 degrees C. More importantly, it has excellent thermal cycle stability. After 300 thermal cycles, the shape of the samples remains unchanged, and the samples retained 94.4 % of the compressive strength, 98.8 % of the thermal conductivity and the thermal density was almost unchanged. In addition, the cost of the sample was only $0.58/kWh. The results indicate that this study provides a novel low-cost method for the preparation of steel slag sensible heat storage materials, which has high potential for application in heat storage systems.