Robotic arm tracking control through smooth switching LPV controller based on LPV modeling and torque approximation

PurposeThis paper aims to propose a new linear parameter varying (LPV) controller for the robot tracking control problem. Using the identification of the robot dynamics in different work space points about modeling trajectory based on the least square of error algorithm, an LPV model for the robotic arm is extracted.Design/methodology/approachParameter set mapping based on parameter component analysis results in a reduced polytopic LPV model that reduces the complexity of the implementation. An approximation of the required torque is computed based on the reduced LPV models. The state-feedback gain of each zone is computed by solving some linear matrix inequalities (LMIs) to sufficiently decrease the time derivative of a Lyapunov function. A novel smoothing method is used for the proposed controller to switch properly in the borders of the zones.FindingsThe polytopic set of the resulting gains creates the smooth switching polytopic LPV (SS-LPV) controller which is applied to the trajectory tracking problem of the six-degree-of-freedom PUMA 560 robotic arm. A sufficient condition ensures that the proposed controller stabilizes the polytopic LPV system against the torque estimation error.Practical implicationsSmoothing of the switching LPV controller is performed by defining some tolerances and creating some quasi-zones in the borders of the main zones leading to the compressed main zones. The proposed torque estimation is not a model-based technique; so the model variation and other disturbances cannot destroy the performance of the suggested controller. The proposed control scheme does not have any considerable computational load, because the control gains are obtained offline by solving some LMIs, and the torque computation is done online by a simple polytopic-based equation.Originality/valueIn this paper, a new SS-LPV controller is addressed for the trajectory tracking problem of robotic arms. Robot workspace is zoned into some main zones in such a way that the number of models in each zone is almost equal. Data obtained from the modeling trajectory is used to design the state-feedback control gain.