Evaluation of a resistor-chain-based SiPM detector for positron annihilation lifetime measurement

Silicon photomultipliers (SiPMs) have great potential to replace photomultiplier tubes (PMTs) and exceed their performance in positron annihilation parameter-measurement systems. However, due to the limited active area of a single SiPM, it only covers a small 7-ray emission acceptance range and provides position information over a very small region. Using a SiPM array is a good way to overcome these problems. In this study, a resistor -chain-based SiPM detector was designed and evaluated for positron annihilation lifetime (PAL) measurements. This detector uses a 1 x 4 scintillator array, a 1 x 4 SiPM array, and a resistor-chain readout circuit to obtain position, energy, and timing information about 1275 and 511 keV 7-rays, with the readout pulses serving as both the position, energy, and timing signals. A comprehensive evaluation was conducted to assess the detector in terms of position profile, energy resolution, and time resolution. The position profiles showed that all the crystal elements in the lutetium fine silicate scintillator array were clearly resolved. The detector had an energy resolution of 11.3 +/- 0.9% and a time resolution of 198 +/- 9 ps. A total of 32 PAL spectra were obtained using two SiPM array detectors. The PAL in yttria-stabilized zirconia (YSZ) sample was accurately verified using the summed PAL spectrum. The developed SiPM detector provides good performance for PAL measurements and could be used to build a high-performance PAL spectrometer.