Preparation and Characteristics of the Fired Bricks Produced from Polyaluminum Chloride Slag and Glass Powder

Polyaluminum chloride slag produced in the production of water treatment agents pollutes the environment and wastes land resources in the process of landfill and waste. In order to solve the resource waste of researching polyaluminum chloride slag, it was used to prepare sintered bricks. In this study, sintered bricks were prepared from polyaluminum chloride slag and glass powder. Taking compressive strength, water absorption, linear shrinkage and bulk density as measurement indexes, the effects of the glass powder content (0-10 wt%), molding moisture (10-20%), molding pressure (15-27.5 MPa), heating method (heat preservation at 400 degrees C and 1000 degrees C for 2 h, heat preservation at 500 degrees C and 1000 degrees C for 2 h, and heat preservation at 1000 degrees C for 2 h), heating rate (2-10 degrees C/min) and sintering temperature (900-1100 degrees C) on the performance of sintered brick and the conditions for meeting Chinese standards were studied. Then, the sintered bricks prepared at different temperatures were characterized by X-ray diffraction and scanning electron microscopy. The results show that the compressive strength (bulk density) increases and the water absorption decreases with the increase of the glass powder content, molding pressure, molding moisture and sintering temperature. Moreover, the linear shrinkage increases with the increase of the molding pressure, molding moisture and sintering temperature, but decreases with the increase of the glass powder content. When the glass powder content of the sintered brick is 10 wt%, with molding moisture of 20 wt%, molding pressure of 25 MPa, heating mode to directly raise the temperature to the target temperature, heating speed of 10 degrees C/min and sintering temperature of 1100 degrees C, the properties, pH value and leaching toxicity of sintered bricks meet the requirements of Chinese standard brick MU15. XRD and SEM analyses showed that with the increase of the sintering temperature, new albite and amphibole phases were formed in the structure, and quartz and other silicate minerals melted to form a liquid phase, making the structure more compact and the performance better. The research results provide a reference for the comprehensive utilization of polyaluminum chloride slag.