Design of birch plywood as gusset plates in timber-timber uniaxial tension connections: Influence of fastener pattern, face grain orientation, and discussions based on the Whitmore effective width theory

This study reveals timber-timber composite joints consisting of glulam pieces and birch plywood plates with three different load-to-face grain angles. Utilizing a similar number of fasteners and arranging the fastener array from narrow to wide, uniaxial tension specimens were manufactured with four different fastener patterns. The thickness of birch plywood was intentionally underdesigned so that the failure modes for all connections were net tension failure of birch plywood plates. Thereafter, the influence of the fastener pattern and face grain orientation on the load-bearing capacity and stiffness of the investigated composite joints was studied. The load capacity and nominal strength generally increased when the nail patterns varied from narrow to wide. This observation was associated with the Whitmore effective width theory (load spread angle) in steel gusset plate design. Moreover, to derive valid analytical methods to predict the nettension capacity of birch plywood plates, the classic spread angle model that assumes rectangular stress blocks and the modified spread angle model that considers the summation of stresses from each fastener row were discussed. Both models were adopted to predict the net tension capacity of investigated specimens at 0. In addition, the stiffness of joints was measured and compared with slip modulus formulas in Eurocode 5. The measured local stiffness values were found to be independent of the fastener pattern and load-face grain angles. The analytical slip modulus assuming the case without predrilling exhibited a satisfactory prediction, while formulas assuming the case with predrilling tend to give overestimations.