Aluminum alloy thick plate laser scanning wire filling welding porosity suppression

被引：0

作者：

Zou J. ^{[1
]}

Li L. ^{[1
]}

Gong J. ^{[2
]}

Huang R. ^{[1
]}

Li Y. ^{[3
]}

机构：

[1] Harbin Welding Institute Limited Company, Harbin

[2] State Key Laboratory of Advanced Welding and Joining, Harbin Institute of Technology, Harbin

[3] China Academy of Engineering Physics, Mianyang

来源：

Hanjie Xuebao/Transactions of the China Welding Institution | 2019年 / 40卷 / 10期

关键词：

Aluminum alloy; Laser scanning welding; Narrow gap; Thick plate;

D O I：

10.12073/j.hjxb.2019400261

中图分类号：

学科分类号：

摘要：

To reduce big plate of 5A06 aluminum alloy laser welding defects, which enhances the stability of welding process, using a laser beam in a certain way of scanning new welding method, welding laser beam was studied different trajectories, amplitude, frequency of deep penetration laser welding aluminum alloy weld porosity, and the welding groove design optimization based on the application of narrow gap scanning laser wire filling welding technology for 130 mm thick 5A06 aluminum alloy welding test. The results show that when the scanning amplitude of the laser beam is greater than 1 mm and the scanning frequency is near the highest frequency, the porosity of the weld can be greatly reduced. The welding method of narrow gap laser scanning wire filling was adopted to obtain the high-quality welding joints of 130 mm 5A06 aluminum alloy with average porosity of 1%, no side wall non-fusion, interlayer non-fusion, crack and other welding defects. © 2019, Editorial Board of Transactions of the China Welding Institution, Magazine Agency Welding. All right reserved.

引用

页码：43 / 47and66

页数：4723

共 6 条

[1] Mao Y., Jiang Z., Ke L., Et al., Research progress on metal flow behavior of friction stir welding seam for aluminum alloy thick plate, Journal of Netshape Forming Engineering, 10, 5, pp. 1-15, (2018)
[2] Zhu L., Zheng S., Chen J., Et al., Development of ultra-narrow gap welding with constrained arc by flux band, China Welding, 15, 2, pp. 44-49, (2006)
[3] Bao L., Wang Y., Han T., Et al., Welding technology and development trend of offshore platform, Welding & Joining, 1, pp. 27-36, (2019)
[4] Jokinen T., Kujanpaa V.B.L.L., Multi-pass Nd: yag laser welding of thick section austenitic stainless steel, Proceedings of Laser Inst America, pp. 438-447, (2001)
[5] Lei Z., Li Y., Chen Y., Et al., Effect of process parameters on porosity formation ratio in dual-beam laser welding of aluminum alloys with filler wire, Transactions of the China Welding Institution, 34, 2, pp. 40-44, (2013)
[6] Zhao L., Zhang X., Chen W., Et al., Repression of porosity with beam weaving laser welding, Transactions of the China Welding Institution, 25, 1, pp. 29-32, (2004)

← 1 →