Anti-windup design for PI-type speed controller based on nonlinear compensation and disturbance suppression

被引:3
|
作者
Institute of Automation, University of Chinese Academy of Sciences, Beijing [1 ]
100190, China
机构
来源
关键词
Controllers - Synchronous motors - Friction - Permanent magnets - Speed control - Time domain analysis;
D O I
10.11817/j.issn.1672-7207.2015.09.009
中图分类号
学科分类号
摘要
In order to solve the problem of dynamic quality deterioration caused by the proportional plus integral (PI) integral saturation of speed regulator in permanent magnet synchronous motor servo system, a novel anti-windup(AW) design was proposed. Uncertainties in the mode were regarded as a disturbance of the system by the AW method firstly. Then in order to improve the system low performance and disturbance rejection property a compound control method, which combined model-based friction compensation with disturbance observer compensation, was designed for speed loop based on PI control strategy. Finally, the desaturation system response of re-entering the PI mode from proportional (P) mode was used as a system response with an initial value, and the error and integral value condition which ensured the system non-overshoot were derived using dynamic responses of the system error equation in time-domain. When the system was saturated, it ran at maximum acceleration. Until the condition was satisfied, the PI mode was re-entered and an initial value was assigned to the integrator. The results show that this method ensures the desaturation system excellent dynamic performance and non-overshoot operation. Compared with the existing conditional integration and its improved methods, the simulated and experimental results demonstrate the feasibility and advantage of the new AW design. © 2015, Central South University of Technology. All right reserved.
引用
收藏
相关论文
共 50 条
  • [1] Anti-Windup PI Controller for Speed Control of Brushless DC Motor
    John, Greeshma Sarah
    Vijayan, Abhilash T.
    2017 IEEE INTERNATIONAL CONFERENCE ON POWER, CONTROL, SIGNALS AND INSTRUMENTATION ENGINEERING (ICPCSI), 2017, : 1068 - 1073
  • [2] A Novel Piecewise Anti-Windup Design for Speed Loop PI Controller of PMSM Servo System
    Yang Ming
    Niu Li
    Xu Dian-guo
    2012 15TH INTERNATIONAL POWER ELECTRONICS AND MOTION CONTROL CONFERENCE (EPE/PEMC), 2012,
  • [3] Design of anti-windup controller based on matrix inequalities
    Saeki, M
    Wada, N
    PROCEEDINGS OF THE 35TH IEEE CONFERENCE ON DECISION AND CONTROL, VOLS 1-4, 1996, : 261 - 262
  • [4] PI anti-windup speed control of Permanent Magnet Synchronous Motor based on feedforward compensation
    Zhetpissov, Yernar
    Kaibaldiyev, Azamat
    Ton Duc Do
    12TH INTERNATIONAL CONFERENCE ELEKTRO 2018, 2018,
  • [5] An Improved Anti-windup Control Using a PI Controller
    Sakai, Kyohei
    Ishida, Yoshihisa
    2015 THIRD INTERNATIONAL CONFERENCE ON ARTIFICIAL INTELLIGENCE, MODELLING AND SIMULATION (AIMS 2015), 2015, : 197 - 201
  • [6] Use of scheduling for anti-windup controller design
    Sajjadi-Kia, Solmaz
    Jabbari, Faryar
    2007 AMERICAN CONTROL CONFERENCE, VOLS 1-13, 2007, : 2005 - 2010
  • [7] A design of an improved anti-windup control using a pi controller based on a pole placement method
    Sakai K.
    Ishida Y.
    International Journal of Simulation: Systems, Science and Technology, 2016, 17 (34): : 1.1 - 1.7
  • [8] Design of the Position Controller for the Leaves of MLC Based on Anti-windup
    Zhang, Xin
    Dang, Jianwu
    Wang, Yangping
    PROCEEDINGS OF THE 2016 INTERNATIONAL CONFERENCE ON SENSOR NETWORK AND COMPUTER ENGINEERING, 2016, 68 : 580 - 584
  • [9] Sliding Mode Observer Based Anti-Windup PI Speed Controller for Permanent Magnet Synchronous Motors
    Yu, Shuanghe
    Yang, Zhenqiang
    Du, Jialu
    Ma, Jingcong
    ADVANCED INTELLIGENT COMPUTING THEORIES AND APPLICATIONS: WITH ASPECTS OF ARTIFICIAL INTELLIGENCE, 2012, 6839 : 325 - +
  • [10] PSO-Based Nonlinear PI-type Controller Design for Boost Converter
    Seo, Sang-Wha
    Kim, Yong
    Choi, Han Ho
    JOURNAL OF ELECTRICAL ENGINEERING & TECHNOLOGY, 2018, 13 (01) : 211 - 219