Preventive maintenance decision model of multi-component system with degradation interaction

被引：1
|
作者：
Yang Z. [1 ]
Zhao J. [1 ]
Cheng Z. [1 ]
机构：
[1] Department of Management Engineering, Shijiazhuang Campus, Army Engineering University, Shijiazhuang
来源：
Xi Tong Gong Cheng Yu Dian Zi Ji Shu/Systems Engineering and Electronics | 2018年 / 40卷 / 04期
关键词：
Degradation interaction; Degradation rate; Maintenance decision; Multi-component system; Preventive maintenance;
D O I：
10.3969/j.issn.1001-506X.2018.04.16
中图分类号：
学科分类号：
摘要：
In general, the dependent failure among different components is considered in maintenance decision of the complex multi-component system. The degradation process analysis model of the degradation interaction multi-componerit system is built considering the degradation rate of one component is affected by the degradation levels of dependent components. On the basis of non-decreasing degradation assumption, the reliability functions of the system and components are derived. Then, the preventive maintenance policy for different component types is put forward, and the maintenance decision model with the goal of minimal per unit cost is built. Finally, taking a two-component system as an example, the accuracy of proposed reliability models is examined, and the optimal preventive maintenance policy for the system is derived, which verifies the reasonability and effectiveness of the maintenance decision model. © 2018, Editorial Office of Systems Engineering and Electronics. All right reserved.
引用
收藏
页码：823 / 832
页数：9
相关论文
共 22 条
  • [1] Murthy D., Nguyen D., Study of two-component system with failure interaction, Naval Research Logistics, 32, 2, pp. 239-247, (1985)
  • [2] Murthy D., Nguyen D., Study of a multi-component system with failure interaction, European Journal of Operational Research, 21, 3, pp. 330-338, (1985)
  • [3] Zequeira R.I., Berenguer C., On the inspection policy of a two-component parallel system with failure interaction, Reliability Engineering and System Safety, 88, 1, pp. 99-107, (2005)
  • [4] Sun Y., Ma L., Mathew J., An analytical model for interactive failures, Reliability Engineering and System Safety, 91, 5, pp. 495-504, (2006)
  • [5] Golmakani H.R., Moakedi H., Periodic inspection optimization model for a two-component repairable system with failure interaction, Computers and Industrial Engineering, 63, 3, pp. 540-545, (2012)
  • [6] Zhou J.Y., Xie L.Y., Wang X.M., Analysis for common cause failure and reliability model in multi-state systems, Journal of Mechanical Engineering, 41, 6, pp. 66-70, (2005)
  • [7] Levitin G., Incorporating common-cause failures into non-repairable multistate series-parallel system analysis, IEEE Trans. on Reliability, 50, 4, pp. 380-388, (2001)
  • [8] Li C.Y., Chen X., Yi X.S., Et al., Analysis of k-out-of-n: G systems subject to common cause failures based on Markov process, Systems Engineering and Electronics, 31, 11, pp. 2793-2796, (2009)
  • [9] Hsieh M.H., Jeng S.L., Shen P.S., Assessing device reliability based on scheduled discrete degradation measurements, Probabilistic Engineering Mechanics, 24, 2, pp. 151-158, (2009)
  • [10] Sari J.K., Newby M.J., Brombacher A.C., Bivariate constant stress degradation model: LED lighting system reliability estimation with two-stage modeling, Quality and Reliability Engineering International, 25, 8, pp. 1067-1084, (2009)
123