Numerical simulation of the flow field in a wide slab continuous casting mold

被引：0
|
作者：
Jiang P.-G. [1 ,2 ]
Lai C.-B. [2 ]
机构：
[1] State Key Laboratory od Adanced Metallury, University of Science and Technoliogy Beijing, Beijing
[2] Institute of Metallurgical and Chemical Engineering, Jiang Xi University of Science and Technology, Ganzhou
来源：
Jiang, Ping-Guo (Pingguo_jiang@163.com) | 2016年 / Science Press卷 / 38期
关键词：
Mold; Nozzle shape; Numerical simulation; Surface velocity;
D O I：
10.13374/j.issn2095-9389.2016.s1.009
中图分类号：
学科分类号：
摘要：
The surface fluctuation and slag entrapment involved in the wide slab continuous casting mold of 150 mm×1503 mm in a steel plant was caculated by FLUENT software. Surface velocity was set as the main measure to study about port angle and guide angular shape of the nozzle influence on flow field. The calculation results show that under the condition of original nozzle, the surface velocity was large, but the impact depth was small and the fluctuation was severe. Entrapment of slag was serious. After changed the angle of the outlet, the mold surface velocity remained large and severe entrapment of slag. When scheme 3 (outlet lead angle changed shape to tangent) was applied, surface velocity reduced from 0.6 m/s to 0.2 m/s, impact depth improved, flow field character became better, and problem of slag entrapment was resolved. © All right reserved.
引用
收藏
页码：50 / 55
页数：5
相关论文
共 9 条
  • [1] Cai K.Y., Billet Quality Control, (2010)
  • [2] Zhang D.J., Physical Simulation Study Slab Continuous Casting of Molten Steel Flow Behavior, (2009)
  • [3] Shen Q.Z., Zhu B.L., Wang J.J., Et al., Numerical simulation of fluid flowing in concasting mould for wide slab, Special Steel, 28, 3, (2007)
  • [4] Liu G.L., Wu S.Z., Numerical simulation on the surface fluctuation of molten steel in a wide slab continuous casting mold, J Univ Sci Technol Beijing, 31, 2, (2009)
  • [5] Shen Q.Z., Zhu B.L., Numerical simulation of optimizing SEN structure for wide slab caster mold, Iron Steel Vanadium Titanium, 28, 1, (2007)
  • [6] Takatani K., Mathematical model for transient fluid flow in a continuous casting mold, ISIJ Int, 41, 10, (2001)
  • [7] Li J.Y., Zhang L.F., Wang Q.Q., Numerical simulation of flow field in a slab continuous casting mold, Chin J Process Eng, 12, 6, (2012)
  • [8] Miranda R., Experimental and numerical analysis of the free surface in a water model of a slab continuous casting mold, ISIJ Int, 45, 11, (2005)
  • [9] Ho Y.H., Chen C.H., Hwang W.S., Analysis of molten steel flow in slab continuous caster mold, ISIJ Int, 34, 3, (1994)
1