Cooling simulation of plastic injection molding

被引：0
|
作者：
机构：
[1] Guo, Z.Y.
[2] Hu, J.Q.
[3] Li, D.Q.
来源：
Guo, Z.Y. | 2001年 / Harbin Institute of Technology卷 / 08期
关键词：
D O I：
暂无
中图分类号：
学科分类号：
摘要：
引用
收藏
相关论文
共 50 条
  • [1] Spiral and conformal cooling in plastic injection molding
    Wang, Yu
    Yu, Kai-Min
    Wang, Charlie C. L.
    COMPUTER-AIDED DESIGN, 2015, 63 : 1 - 11
  • [2] Simulation of cooling process of injection molding
    State Key Laboratory of Die/Mold Technology, Huazhong University of Science and Technology, Wuhan 430074, China
    Prog Nat Sci, 2 (233-234):
  • [3] Simulation of cooling process of injection molding
    卢义强
    李德群
    肖景容
    ProgressinNaturalScience, 1996, (02) : 101 - 108
  • [4] Optimization of cooling pipe system for plastic injection molding
    Matsumori, Tadayoshi
    Yamazaki, Koetsu
    Kitayama, Satoshi
    Matsui, Yoshio
    CJK-OSM 4: The Fourth China-Japan-Korea Joint Symposium on Optimization of Structural and Mechanical Systems, 2006, : 137 - 142
  • [5] Numerical simulation of cooling stage of injection molding
    Chen, Jing-Bo
    Shen, Chang-Yu
    Wang, Zhen-Fei
    Liu, Chun-Tai
    Gaofenzi Cailiao Kexue Yu Gongcheng/Polymeric Materials Science and Engineering, 2002, 18 (04):
  • [6] SIMULATION OF COOLING PROCESS OF INJECTION-MOLDING
    URABE, K
    FUJITA, H
    ITOH, T
    SHARP TECHNICAL JOURNAL, 1988, (40): : 91 - 94
  • [7] Three dimensional simulation of plastic injection molding
    Yan, Bo
    Li, Yang
    Li, Dequn
    Kong, Xiao
    Huazhong Keji Daxue Xuebao (Ziran Kexue Ban)/Journal of Huazhong University of Science and Technology (Natural Science Edition), 2010, 38 (02): : 68 - 71
  • [8] Cavity pressure control during cooling in plastic injection molding
    Pramujati, B.
    Dubay, R.
    Samaan, C.
    ADVANCES IN POLYMER TECHNOLOGY, 2006, 25 (03) : 170 - 181
  • [9] Three-dimensional simulation of plastic injection molding
    Talwar, K
    Costa, F
    Rajupalem, V
    Antanovski, L
    Friedl, C
    CONFERENCE PROCEEDINGS AT ANTEC '98: PLASTICS ON MY MIND, VOLS I-3: VOL I; PROCESSING, VOL II; SPECIAL AREAS, VOL III; MATERIALS, 1998, 44 : 562 - 566
  • [10] Intelligent CAE simulation of plastic injection molding for integration
    Zhou, Huamin
    Li, Dequn
    Yan, Litang
    Liu, Laiying
    Huazhong Keji Daxue Xuebao (Ziran Kexue Ban)/Journal of Huazhong University of Science and Technology (Natural Science Edition), 2002, 30 (03):
12345