A self-calibration method of non-contact voltage measurement based on impedance transformation

被引：0
|
作者：
Huang R. [1 ]
Suo C. [1 ]
Zhang W. [2 ]
Zhu J. [1 ]
Zou X. [2 ]
机构：
[1] College of Science, Kunming University of Science and Technology, Kunming
[2] College of Mechanical and Electrical Engineering, Kunming University of Science and Technology, Kunming
来源：
Yi Qi Yi Biao Xue Bao/Chinese Journal of Scientific Instrument | 2023年 / 44卷 / 03期
关键词：
capacitive coupling; impedance transformation; non-contact; self-calibration; voltage measurement;
D O I：
10.19650/j.cnki.cjsi.J2210805
中图分类号：
学科分类号：
摘要：
For the application of capacitance-coupled non-contact voltage measurement, the coupling capacitance between probe and wire is affected by wire diameter, wire insulation material and relative position deviation. It is difficult to determine the voltage division relation and the voltage cannot be reconstructed. In this article, a self-calibration method of non-contact voltage measurement based on impedance transformation is proposed to realize the self-calibration of sensor gain in practical measurement. Firstly, the basic principle of capacitive coupling voltage measurement is introduced, from which the problems exist and the self-calibration method based on impedance transformation is proposed. Then, the influence of calibration accuracy on system parameters is analyzed by simulation and the principle of parameter selection is given. On this basis, the sensor probe and the circuit topology are developed. Finally, the accuracy test, anti-interference ability test and scene adaptability test of the sensor prototype are carried out. The accuracy test shows that the maximum relative error of voltage amplitude is 0. 59%, and the phase relative error is 0. 76% . The anti-jamming ability test shows that the coaxial probe has good shielding effect on the surrounding coupling electric field. The scenario adaptability test shows that the maximum relative error is 1. 24% when different types of circuits are tested. © 2023 Science Press. All rights reserved.
引用
收藏
页码：137 / 145
页数：8
相关论文
共 25 条
  • [1] LI ZH, ZHAO SH, HU W ZH, Et al., A review of high voltage measurement technology research, High Voltage Technology, 44, 12, pp. 3910-3919, (2018)
  • [2] MU ZH, JIANG B, ZHAO W, Et al., A review of transient overvoltage measurement techniques for power systems, Electrical Measurement and Instrumentation, 59, 5, pp. 1-13, (2022)
  • [3] YANG Q, DONG F N, LUO M D, Et al., Broadband voltage sensing methods and their data applications, High Voltage Technology, 47, 6, pp. 1969-1983, (2021)
  • [4] AUTHONY J P, SLAWOMIR J N., Design and development of non-contact bio-potential electrodes for pervasive health monitoring applications, Biosensors, 7, 1, (2017)
  • [5] WANG Y F, LI J T, XU ZH Y, Et al., A non-contact ECG measurement method based on capacitance coupling electrodes, Chinese Journal of Scientific Instrument, 43, 2, pp. 138-147, (2022)
  • [6] YANG B, DONG Y G., Capacitively coupled non-contact electrodes and ECG signal acquisition [ J ], Chinese Journal of Scientific Instrument, 36, 5, pp. 1072-1078, (2015)
  • [7] SUNG Y C, XIAO F C, XIN Z, Et al., Transfer-power measurement using a non-contact method for fair and accurate metering of wireless power transfer in electric vehicles, IEEE Transactions on Power Electronics, 37, 2, pp. 1244-1271, (2022)
  • [8] SIMA W X, ZHANG H J, YANG M, Et al., Statistical analysis of measured lightning intrusion overvoltage amplitude and waveform characteristics in a substation 10 kV system, High Voltage Technology, 47, 1, pp. 214-222, (2021)
  • [9] HAN R, YANG Q, SIMA WX, Et al., Non-contact measurement of lightning and switching transient overvoltage based on capacitive coupling and pockels effects [ J ], Electric Power Systems Research, 139, pp. 93-100, (2016)
  • [10] YAN X C, WANG J G, SHEN Z L, Et al., A self-decoupling contactless overvoltage measurement method based on optimization of measuring point, IEEE Transactions on Instrumentation and Measurement, 71, pp. 1-11, (2022)
123