Analysis of Dynamic Characteristics of Four-rotor Aircraft Gearbox-arm Component

被引：0
|
作者：
Zhao W. [1 ]
Sun X. [1 ]
Zhang W. [1 ]
Zheng P. [1 ]
Yang F. [1 ]
机构：
[1] School of Mechanical Engineering, Shenyang University of Technology, Shenyang
来源：
Binggong Xuebao/Acta Armamentarii | 2022年 / 43卷 / 05期
关键词：
Dynamic characteristics; Four-rotor aircraft; Gearbox-arm component; Length-to-diameter ratio; Modal analysis; Stiffness; Vibration acceleration;
D O I：
10.12382/bgxb.2021.0001
中图分类号：
学科分类号：
摘要：
The dynamic characteristics of gearbox-arm component are analyzed to improve the flight stability of a heavy-duty oil-powered four-rotor aircraft. The Lanczos eigenvalue solver is used to solve the modal of gearbox-arm component. The vibration acceleration value at the center of the component is collected through experiment, and the length-to-diameter ratio of mandrel is optimized. Runge-Kutta method is used to solve the dynamic equation of the component, and the law of vibration and influencing factors of the component are summarized. The results show that the mandrel's length-to-diameter ratio greater than 20 will produce larger bending vibration. The length-to-diameter ratio (<14) of the mandrel can be optimized to change the natural frequency of its vibration, and avoid the excitation frequency and frequency multiplication. The vibration acceleration increases first and then decreases with the increase in rotating speed, and reaches the maximum when the excitation frequency is equal to the natural frequency of the system. The stiffness of the system is improved to achieve vibration reduction by optimizing the angle of the inclined support. © 2022, Editorial Board of Acta Armamentarii. All right reserved.
引用
收藏
页码：1175 / 1184
页数：9
相关论文
共 20 条
  • [1] JUNG S, JO Y, KIM Y J., Aerial surveillance with low-altitude long-endurance tethered multirotor UAVs using photovoltaic power management system, Energies, 12, 7, (2019)
  • [2] SUN X H., Analysis on mechanical performance of oil-powered quadcopter, (2020)
  • [3] ZHENG C, TANG P, LI Q S., Design of flight control law for tilt-rotor aircraft based on incremental dynamic inversion, Acta Armamentarii, 40, 12, pp. 2457-2466, (2019)
  • [4] ABDULKERIN F S, ERDINC A., Design of a novel tilt-roll rotor quadrotor UAV, Journal of Intelligent & Robotic Systems, 84, pp. 575-599, (2016)
  • [5] SINSAY J D., Re-imagining rotorcraft advanced design, The Aeronautical Journal, 122, 1256, pp. 1497-1521, (2018)
  • [6] XIAN B, LIU Y, ZHANG X, Et al., Autonomous flight control of a micro quadrotor unmanned aerial vehicle using optical flow, Journal of Mechanical Engineering, 51, 9, pp. 58-63, (2015)
  • [7] LI X M, MAO Q, GAN Q T, Et al., Flight control strategy for distributed UAV formation under the conditions of bounded time-varying delay and jointly-connected topology, Acta Armamentarii, 40, 6, pp. 1179-1189, (2019)
  • [8] YUAN C H, ZHANG W, MU X., Adaptive optimal decoupling control in helicopter rotor concordant loading system, China Mechanical Engineering, 18, 22, pp. 2691-2696, (2007)
  • [9] LIU Y P, CHEN C, ZHANG Y H, Et al., Dynamics modeling and stability analysis of a ducted fan unmanned aerial vehicle, China Mechanical Engineering, 27, 14, pp. 1852-1856, (2016)
  • [10] PEI Y H., Analysis of dynamic characteristics of multi-rotor UAV and optimization of landing gear connector, (2016)
12