Research on buckling characteristics of offshore wind power structure supported by single-cylinder multi-cell bucket foundation

被引：0
|
作者：
Wang H. [1 ,2 ]
Liu W. [1 ,2 ]
Yan X. [3 ]
Lian J. [1 ,2 ]
机构：
[1] State Key Laboratory of Hydraulic Engineering Simulation and Safety, Tianjin University, Tianjin
[2] School of Civil Engineering, Tianjin University, Tianjin
[3] Airport College, Civil Aviation University of China, Tianjin
来源：
Taiyangneng Xuebao/Acta Energiae Solaris Sinica | 2022年 / 43卷 / 07期
关键词：
Arc-length method; Bucket foundation; Buckling; Nonlinear analysis; Offshore wind power; Stiffeners;
D O I：
10.19912/j.0254-0096.tynxb.2020-1086
中图分类号：
学科分类号：
摘要：
The cylinder of offshore wind power bucket foundation is prone to buckling and instability when it is installed into the soil, which seriously affects the safety of the foundation structure. The thesis analyzes the stability of the bucket foundation in the sinking process and studies its instability mode and critical buckling load as well as the influence of the compartment and longitudinal stiffeners on the critical value of the internal and external pressure difference of the bucket. The results showed that the instability of the cylinder of the bucket foundation belongs to the extreme point instability and the nonlinear method should be used to determine the critical load of structural instability. Both the compartment and the stiffeners with appropriate spacing can increase the critical buckling load of the bucket. However, as the top of the tube top approaches the mud surface, its lifting effect gradually decreases, and the control condition of the internal and external pressure difference of the bucket is changed to prevent the soil in the bucket from permeating damage. © 2022, Solar Energy Periodical Office Co., Ltd. All right reserved.
引用
收藏
页码：402 / 408
页数：6
相关论文
共 19 条
  • [1] ZHAO Y, LIAN C, LIAN J J, Et al., Optimization inversion of multi-layer subsoil parameters for offshore wind turbine structure supported by bucket foundation, Journal of Tianjin University(science and technology), 52, 4, pp. 423-429, (2019)
  • [2] QI Y, LIU R, LIAN J J., Model test of bucket foundation suction installation in cohesionless soil, Rock and soil mechanics, 39, 1, pp. 139-150, (2018)
  • [3] LIAN J J, CHEN F, YANG X, Et al., Suction installation and leveling of composite bucket foundation for offshore wind turbines, Journal of Tianjin University(science and technology), 47, 11, pp. 987-993, (2014)
  • [4] SUN Y., Imperfection sensitivity of composite cylindrical shell under external pressure, (2017)
  • [5] BAKMAR C L, AHLE K, NIELSEN S A, Et al., The monopod bucket foundation: recent experiences and challenges ahead, European Offshore Wind Conference & Exhibition, (2009)
  • [6] MADSEN S, ANDERSEN L V, IBSEN L B., Numerical buckling analysis of large suction caissons for wind turbines on deep water, Engineering structures, 57, pp. 443-452, (2013)
  • [7] GB 50884-2013, Technical specification for steel silos (with clauses)
  • [8] EN 1993-1-6-2007, Eurocode 3: design of steel structures (Part 1-6): strength and stability of shell structures
  • [9] HAN Q H, JIN H, AI J, Et al., Analysis of the overall buckling load for engineering structures, Journal of Tianjin University, 38, 12, pp. 1051-1057, (2005)
  • [10] ZHANG C, SHU G P., Bearing capacity axial pressure and pressure uniformity within the cylindrical shell of steel silo buckling, Special structures, 32, 4, pp. 1-7, (2015)
12