Aero-engine stall/surge airworthiness certification under combined pressure-temperature distortion

被引：0
|
作者：
Li Z. [1 ]
Chen J. [1 ]
Zhu X. [1 ]
Zhao Y. [1 ]
机构：
[1] Research Institute of Aero-Engine, Beijing University, Beijing
来源：
Hangkong Dongli Xuebao/Journal of Aerospace Power | 2023年 / 38卷 / 12期
关键词：
airworthiness certification; combined pressure-temperature distortion; compliance method; stall/surge; total temperature distortion;
D O I：
10.13224/j.cnki.jasp.20220107
中图分类号：
学科分类号：
摘要：
Due to its complex nonlinear mechanism， the combined distortion of pressure and temperature poses great challenges to the stability evaluation. Through numerical simulation of a single stage axial compressor，the influence of the combined pressure-temperature distortion on the stability of the compressor under different combined distortion intensities and combined phase angles was investigated. The results show that the smaller the phase angle is，the greater the loss of stability margin is，and the maximum loss of surge margin is at 0° phase angle. Changing the total pressure distortion intensity affects the relative Mach number distribution of the aerodynamic measurement section and the inlet angle of attack. The increase of the total pressure distortion intensity leads to the delay of the leading edge overflow，so the flow difference at the instability point is small under different total pressure distortion intensities. Finally， according to the requirements of relevant clauses， the verification process of aeroengine stall/surge compliance under the combined distortion of pressure and temperature is established. © 2023 BUAA Press. All rights reserved.
引用
收藏
页码：3050 / 3062
页数：12
相关论文
共 19 条
  • [1] CHESHIRE L J., The design and development of centrifugal compressors for aircraft gas turbines, Proceedings of the Institution of Mechanical Engineers, 153, 1, pp. 426-440, (1945)
  • [2] (2015)
  • [3] WEI Binghai, WU Keqi, Characteristics of stall surge of fan and its preventive measures, Fluid Machinery, 29, 6, pp. 28-31, (2001)
  • [4] XIA Lian, GU Yang, Et al., An experimental investigation of stall/surge of a multistage axial compressor in different conditions, Gas Turbine Experiment and Research, 14, 3, pp. 16-23, (2001)
  • [5] (2011)
  • [6] (2021)
  • [7] pp. 1-42, (2005)
  • [8] LEINHOS D C，, SCHMID N R，, FOTTNER L., The influence of transient inlet distortions on the instability inception of a low-pressure compressor in a turbofan engine, Journal of Turbomachinery, 123, 1, pp. 5-8, (2001)
  • [9] GUNN E J, TOOZE S E, HALL C A, Et al., An experimental study of loss sources in a fan operating with continuous inlet stagnation pressure distortion, Journal of Turbomachinery, 135, 5, (2013)
  • [10] FU Wenjun, TU Baofeng, HU Jun, Et al., Experimental and numerical investigation on aerodynamic stability of steaming estion in a compressor, Journal of Aerospace Power, 35, 1, pp. 205-214, (2020)
12