Field measurement of stack effect for super high-rise buildings and their stack pressure characteristics

被引：0
|
作者：
Yang Y. [1 ]
Zhong S. [1 ]
Xie X. [1 ]
Lu X. [2 ]
Chen C. [2 ]
Wan T. [1 ]
机构：
[1] State Key Laboratory of Subtropical Building Science, South China University of Technology, Guangzhou
[2] Hitachi Elevator (China) Company Limited, Guangzhou
来源：
Jianzhu Jiegou Xuebao/Journal of Building Structures | 2023年 / 44卷 / 03期
关键词：
differential pressure characteristic; field measurement; stack effect; super high-rise building;
D O I：
10.14006/j.jzjgxb.2021.0172
中图分类号：
学科分类号：
摘要：
In order to obtain the data of the stack pressure distributions of high-rise buildings in natural meteorological conditions, a three-year’s field measurement of the stack effect of totally 13 high-rise residential and super high-rise commercial buildings in winter, which are located in the Northeast, the East, and the South China respectively, has been performed in this study. It is found that the distribution of the pressure difference in the whole elevator shaft is approximately linear, and the maximum absolute values always occur at the bottom and top floors. For example, the maximum stack pressure under investigation reaches as high as 171.0 Pa among seven residential buildings, and 117.3 Pa among six commercial buildings respectively, which far exceeds the bearing thresholds of the elevator systems, and that is exactly the reason for the elevator failure. The concept of the stack pressure coefficient of elevator is firstly introduced, and then a new evaluation model for estimating the maximum stack effect pressure is proposed on the basis of the classical model. The values of the stack pressure coefficient of the buildings are then calculated according to the field measurement data, which are all greater than 0.5. Compared with other existing models, the model possesses the advantages of quantifying the total airtightness of the building by combining with the field measurement data, and can be used to calculate the possible maximum stack pressure that the building might experience. © 2023 Science Press. All rights reserved.
引用
收藏
页码：148 / 156
页数：8
相关论文
共 18 条
  • [1] TAMURA G T, WILSON A G., Pressure differences caused by chimney effect in three high buildings, ASHRAE Trans, 73, 2, (1967)
  • [2] TAMURA G T, WILSON A G., Building pressures caused by chimney action and mechanical ventilation, ASHRAE Trans, 73, 2, (1968)
  • [3] TAMURA G T, WILSON A G., Pressure differences caused by wind on two tall buildings [J], ASHRAE Trans, 74, 2, pp. 170-181, (1969)
  • [4] 2017 ASHRAE handbook:fundamentals, (2017)
  • [5] YIN Huabin, Numerical simulation of the stack effect and the combinations of the wind pressure analysis on super high-rise building [D], (2015)
  • [6] YANG Yi, WAN Tengjun, WANG Kui, XIE Zhuangning, Numerical simulation research on combined wind and stack effects of a super high-rise building [J], Journal of Hunan University (Natural Sciences), 45, 11, pp. 10-19, (2018)
  • [7] SHAW C Y, TAMURA G T., The calculation of air infiltration rates caused by wind and stack action for tall buildings, ASHRAE Trans, 83, 2, pp. 145-158, (1977)
  • [8] ETHERIDGE D W., Crack flow equations and scale effect[J], Building and Environment, 12, 3, pp. 181-189, (1977)
  • [9] CHASTAIN J P, COLLIVER D G, WINNER P W., Computation of discharge coefficients for laminar flow in rectangular and circular openings [J], ASHRAE Trans, 93, 2, pp. 2259-2283, (1987)
  • [10] JO J H, LIM J H, SONG S Y, Et al., Characteristics of pressure distribution and solution to the problems caused by stack effect in high-rise residential buildings [J], Building & Environment, 42, 1, pp. 263-277, (2007)
12