Flexible-grounding Active Arc-suppression Method for Distribution Network Based on Double-end Measurement of Ground Parameters and Closed-loop Control

被引：0
|
作者：
Yu Q. [1 ]
Zeng X. [1 ]
Yu K. [1 ]
Li J. [1 ]
Zeng J. [1 ]
Li L. [1 ]
机构：
[1] Hunan Province Key Laboratory of Smart Grids Operation and Control, Changsha University of Science and Technology, Changsha
来源：
Gaodianya Jishu/High Voltage Engineering | 2022年 / 48卷 / 03期
基金：
中国国家自然科学基金;
关键词：
Active arc suppression; Closed-loop control; Damping resistance; Distribution network; Double-ended measurement of ground parameters; Flexible grounding;
D O I：
10.13336/j.1003-6520.hve.20210162
中图分类号：
学科分类号：
摘要：
In consideration of the problem that fault current is difficult to fully compensate and the arc suppression effect is poor after single-phase grounding faults occur in the distribution network with neutral point grounded by the Petersen coil, an active arc-suppression method based on double-end measurement of ground parameters and closed-loop control is proposed, in which fault arc suppression can be realized by injecting a power frequency current into the neutral point of the distribution network. In the double-end measurement method of ground parameters proposed in the paper, the injection transformer of the flexible grounding device is used as the injection end to inject a specific frequency current, and the internal voltage transformer of the Petersen coil is used as the return end to measure the no-load voltage, so as to realize the ground parameter measurement of the distribution network. In this proposed method, the damping resistance of the Petersen coil is considered, and the influence of the leakage impedance of the injection transformer on the measurement accuracy is eliminated, thereby eliminating the errors in the modeling and principle of the traditional ground parameter measurement method. Furthermore, a current closed-loop control method is designed: after the reference value of the injected current is calculated from the measured ground parameters of the distribution network, the proportional resonance (PR) controller is used to correct the difference between the actual value and the reference value of the injected current, and then it is injected into the neutral point of the distribution network by the L-shaped filter circuit, thus the fault phase voltage is effectively suppressed to zero. The simulation and experiment results show that the proposed method has high accuracy and fast response speed, can achieve fast and reliable arc suppression of ground faults, and is suitable for faults with different transition resistances. © 2022, High Voltage Engineering Editorial Department of CEPRI. All right reserved.
引用
收藏
页码：1011 / 1021
页数：10
相关论文
共 26 条
  • [1] LIU Baowen, MA Hongzhong, SHEN Peifeng, Et al., New flexible control system of full compensation single-phase ground fault fundamental current, Proceedings of the CSEE, 36, 9, pp. 2322-2330, (2016)
  • [2] ZHOU Jianghua, WAN Shanming, YAN Wenbo, Et al., Research on transient process analysis and optimization method of flexible grounding in distribution networks, High Voltage Engineering, 45, 10, pp. 3149-3156, (2019)
  • [3] WU Zhengrong, CAI Yingqian, ZHANG Junxiao, Et al., Fault analysis on successive fault of multi-feeders connected to the same bus in resonant grounding system, High Voltage Engineering, 43, 7, pp. 2402-2409, (2017)
  • [4] WEI Xiaohui, SHAO Wenquan, CHENG Yuan, Et al., Review of single-phase grounding fault active arc-suppression technologies in distribution network, Electric Power Engineering Technology, 39, 6, pp. 58-65, (2020)
  • [5] GUO Liwei, XUE Yongduan, XU Bingyin, Et al., Research on effects of neutral grounding modes on power supply reliability in distribution networks, Power System Technology, 39, 8, pp. 2340-2345, (2015)
  • [6] LIU Yugen, WANG Jiannan, MI Hongwei, Et al., Optimization research on neutral grounding mode of 10 kV distribution networks, High Voltage Engineering, 41, 10, pp. 3355-3362, (2015)
  • [7] YAO Huannian, CAO Meiyue, Resonant grounded of power system, pp. 38-39, (2009)
  • [8] SHI Bonian, LI Yan, SUN Gang, Et al., DC fault protection strategy for multi-terminal flexible DC distribution network based on full fault current information, High Voltage Engineering, 45, 10, pp. 3076-3083, (2019)
  • [9] HAN Bowen, WANG Gang, LI Haifeng, Et al., Novel pilot protection scheme for distribution networks with inverter-interfaced distributed generators, High Voltage Engineering, 43, 10, pp. 3453-3462, (2017)
  • [10] ZENG Xiangjun, WANG Yuanyuan, LI Jian, Et al., Novel principle of faults arc extinguishing & feeder protection based on flexible grounding control for distribution networks, Proceedings of the CSEE, 32, 16, pp. 137-143, (2012)
123