Levitation Test and Rotation Experiment of Radial-Type Superconducting Flywheel Energy Storage System Prototype with External Motor

被引：0
|
作者：
Yu Z. [1 ]
Sun X. [1 ]
Qiu Q. [2 ]
Liu Y. [1 ]
Wen C. [1 ]
机构：
[1] Shijiazhuang Tiedao University, Shijiazhuang
[2] Institute of Electrical Engineering, Chinese Academy of Sciences, Beijing
来源：
Diangong Jishu Xuebao/Transactions of China Electrotechnical Society | 2019年 / 34卷 / 10期
关键词：
Electromagnetic distribution; FEM mathematical model; High-temperature superconducting; Rotational characteristics; Superconducting flywheel energy storage system;
D O I：
10.19595/j.cnki.1000-6753.tces.L80255
中图分类号：
学科分类号：
摘要：
A small-capacity radial-type superconducting flywheel energy storage system (SFESS) prototype with an external motor was built for the levitation and rotation experiments. The structure of the prototype and its main components are introduced in detail. Through the potting process and the bonding process, two superconducting magnet stators (SMSs) were set up and tested respectively for levitation. Based on the established FEM mathematical model, the magnetic field distribution of the high-temperature superconducting (HTS) bearing as well as the current density in the HTS bulks during the running of the prototype was studied. The prototype was equipped with the SMS fabricated by the bonding process, and then the free rotations and radial vibration of the rotor at different steady-state speeds were measured. The variation law of the rotor radial variation amplitude was studied by the two-norm method. It is shown that the rotational characteristics are related to the rotor vibration. Below the resonant frequency, the vibration increases significantly with the increase of speed. Limiting rotor vibration amplitude by combined bearing system is an effective approach to improve system speed and mechanical stability. © 2019, Electrical Technology Press Co. Ltd. All right reserved.
引用
收藏
页码：2166 / 2175
页数：9
相关论文
共 30 条
  • [1] Han H.S., Kim D.S., Superconducting Magnet, (2016)
  • [2] Faraji F., Majazi A., Al-Haddad K., A comprehensive review of flywheel energy storage system technology, Renewable and Sustainable Energy Reviews, 67, pp. 477-490, (2017)
  • [3] Strasik M., Hull J.R., Mittleider J.A., Et al., An overview of Boeing flywheel energy storage systems with high-temperature superconducting bearings, Superconductor Science and Technology, 23, 3, (2010)
  • [4] Werfel F.N., Floegel-Delor U., Rothfeld R., Et al., Superconductor bearings, flywheels and trans-portation, Superconductor Science and Technology, 25, 1, (2011)
  • [5] Mukoyama S., Nakao K., Sakamoto H., Et al., Development of superconducting magnetic bearing for 300kW flywheel energy storage system, IEEE Transactions on Applied Superconductivity, 27, 4, pp. 1-4, (2017)
  • [6] Ma G., Liu H., Wang J., Et al., 3D modeling permanent magnet guideway for high temperature superconducting maglev vehicle appli-cation, Journal of Superconductivity and Novel Magnetism, 22, 8, pp. 841-847, (2009)
  • [7] Yu Z., Zhang G., Qiu Q., Et al., Development status of magnetic levitation flywheel energy storage system based on high-temperature superconductor, Transactions of China Electrotechnical Society, 28, 12, pp. 109-118, (2013)
  • [8] Zhu J., Li L., Li X., Et al., Distribution network multi-objective reconfiguration optimization based on status assessment, Power System Protection and Control, 45, 1, pp. 98-103, (2017)
  • [9] Li D., Xu L., Liu X., Et al., Optimal dispatching of microgrid considering the partici-pation of reducible loads, distributed generators (DG) and energy storage units, Power System Protection and Control, 45, 2, pp. 35-41, (2017)
  • [10] Zhao Z., Yang P., Zheng C., Et al., Review on dynamic stability research of microgrid, Transactions of China Electrotechnical Society, 32, 10, pp. 111-122, (2017)
123