Effect of temperature on joint quality in wave soldering of Sn-9Zn-2.5Bi-1.5In lead-free solder alloy

SnZn (tin-zinc) solder has been regarded as a promising lead-free solder material with a low melting point of 198 degrees C, serving as a suitable alternative to both SnPb solder due to its lack of hazardous substances and Sn-Ag-Cu solder because of the high cost associated with silver. Nonetheless, its susceptibility to oxidation hinders solderability and increases soldering defects such as bridging, insufficient fillings, and voids, limiting its use in commercial production. Devices designed with through-hole technology, in contrast to surface-mounted ones, continue to exhibit superior interconnection reliability in such applications. In this investigation on wave soldering, a newly developed lead-free solder, composed of 87% tin, 9% zinc, 2.5% bismuth, and 1.5% indium by weight, was employed under two conditions related to nitrogen content: 1) Ensuring that static oxygen content remained below 3000 ppm. 2) Maintaining soldering section oxygen content below 600 ppm at a conveyor speed of 1200 mm/min. The soldering results were examined at various temperatures of preheating and soldering. It proves that the measured peak temperature of liquid solder T-pL over 230 degrees C makes the bridging defect rate lower than 0.30%. Additionally, setting the peak temperature of solder joint T-pZ above 220 degrees C, along with specific preheating temperatures (105/115/135/145 degrees C), archives 100% vertical filling without significant voids in the solder joints. Moreover, optimizing wave soldering settings, specifically adjusting the wave soldering setting temperature T-s to 235 degrees C, conveyor speed v(c) to 1000 mm/min, resolves soldering defects associated with Sn-9Zn-2.5Bi-1.5In alloy in wave process.