Effect of shear stresses on fibre direction tensile failure using a new simple and reliable test method with thin plies

A new method of creating in-plane combined tension-shear stress states using only tensile loading is proposed. Thin-ply angle-ply carbon/epoxy laminates are sandwiched between unidirectional glass layers to eliminate any stress concentration around the samples ends and gripping zone. Use of the thin plies successfully suppresses early occurrence of other modes of failure i.e. matrix cracking and free-edge delamination, so the first mode of failure is fibre failure in the angle-ply carbon sub-laminate. Compared with other methods of creating combined tension-shear stresses, the proposed technique has a simpler geometry, is significantly easier and cheaper to manufacture and test. Therefore, it provides more repeatable low-scatter experimental results. The obtained experimental results showed that the presence of in-plane shear stresses did not have a significant impact on the tensile fibre-direction failure strain of the tested carbon/epoxy laminate, suggesting that even at high shear stresses, the longitudinal tensile strength of the carbon/epoxy laminate is not significantly reduced.