Experimental study on mechanical performance of reinforced concrete beams shear-strengthened with FRP-UHTCC composite

被引:0
|
作者
Zheng Y. [1 ,2 ,3 ]
Wang W. [3 ]
Dai J. [4 ]
Zhu Z. [3 ]
机构
[1] School of Field Engineering, Army Engineering University of PLA, Nanjing
[2] State Key Laboratory of Disaster Prevention & Mitigation of Explosion & Impact, Army Engineering University of PLA, Nanjing
[3] School of Transportation, Southeast University, Nanjing
[4] Department of Civil and Environmental Engineering, The Hong Kong Polytechnic University, Hong Kong
关键词
FRP grid; RC beam; Shear capacity; Static test; Strengthening; Ultra high toughness cementitious composite;
D O I
10.14006/j.jzjgxb.2017.0175
中图分类号
学科分类号
摘要
Six reinforced concrete (RC) beams shear-strengthened with FRP grid reinforced-ultra high toughness cementitious composite (UHTCC) were tested to investigate the shear performance. The reinforcement ratio of FRP grid and the shear-span of the beams were selected as the test parameters to investigate their effects on the mechanical performance of FRP-UHTCC-strengthened RC beams. A shear capacity formula of FRP-UHTCC-strengthened RC beams was proposed based on the test results. The experimental results show that the failure modes of the tested RC beams are shear compression failure in the shear/flexure region and crushing of concrete in the compression zone. Good bonding performance between the FRP-UHTCC composite and the concrete substrate is observed during the test. The propagation of diagonal cracks in the shear/flexure regions is effectively suppressed. The shear capacity of strengthened RC beams is greatly improved with the increase of reinforcement ratio of FRP grid. The reinforcement effect of this strengthening technique is improved with the increase of the shear-span ratio. The maximum increase in shear capacity reached 61% comparing to the non-strengthened reference beam. The proposed formula is validated through the comparisons between the prediction and the measured shear capacity of RC beams shear-strengthened with FRP-UHTCC composite. © 2019, Editorial Office of Journal of Building Structures. All right reserved.
引用
收藏
页码:118 / 126
页数:8
相关论文
共 32 条
  • [1] Zheng Y., Wang W., Li J., Et al., The constitutive relationship model of ECC composite strengthened with FRP grid under axial loading, Industrial Construction, 46, 5, pp. 12-17, (2016)
  • [2] Zheng Y.Z., Wang W.W., Mosalam K.M., Et al., Mechanical behavior of ultra-high toughness cementitious composite strengthened with fiber reinforced polymer grid, Composite Structures, 184, pp. 1-10, (2018)
  • [3] Huang H., Wang W., Dai J., Experimental study on structural performance of two-span continue GFRP-concrete composite hollow slabs, Journal of Building Structures, 36, 10, pp. 59-65, (2015)
  • [4] Wang W.W., Dai J.G., Harries K.A., Bao Q.H., Prestress losses and flexural behavior of reinforced concrete beams strengthened with post-tensioned CFRP sheets, Journal of Composites for Construction, 16, 2, pp. 207-216, (2012)
  • [5] Wang W.W., Li G., Experimental study and analysis of RC beams strengthened with CFRP laminates under sustaining load, International Journal of Solids and Structures, 43, 6, pp. 1372-1387, (2006)
  • [6] Gao Z., Wang W., Zhang Y., Study on shear capacity of FRP-concrete composite beams based on strut-and-tie model, Journal of Building Structures, 33, 9, pp. 136-140, (2012)
  • [7] Dai J.G., Murnir S., Ding Z., Comparative study of different cement-based inorganic pastes towards the development of FRIP strengthening technology, Journal of Composites for Construction, 18, 3, (2014)
  • [8] Zhu J., Zheng W., Interfacial shear performance in FRP strengthened concrete structures using AASCM as adhesive, Journal of Southeast University (Natural Science Edition), 42, 5, pp. 962-969, (2012)
  • [9] Triantafillou T.C., Plevris N., Strengthening of RC beams with epoxy-bonded fiber-composite materials, Materials and Structures, 25, 148, pp. 201-211, (1992)
  • [10] Ding Z., Dai J.G., Muner S., Study on an improved phosphate cement binder for the development of fiber-reinforced inorganic polymer composites, Polymers, 6, 11, pp. 2819-2831, (2014)