Influence of Gas Type on Surface Discharge Characteristics of PEEK Under Positive Repetitive Square Voltage

被引：0

作者：

Qiu Z. ^{[1
]}

Li X. ^{[1
]}

Li Y. ^{[1
]}

Zhao Z. ^{[1
]}

机构：

[1] State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources, North China Electric Power University, Beijing

来源：

Gaodianya Jishu/High Voltage Engineering | 2023年 / 49卷 / 12期

关键词：

PEEK; positive repetitive square voltage; SF6; surface discharge; time-lag;

D O I：

10.13336/j.1003-6520.hve.20230010

中图分类号：

学科分类号：

摘要：

In order to study the effects of different gases on the surface discharge characteristics of insulating materials of power electronic devices, the surface discharge current pulses of polyetheretherketone(PEEK) under positive repetitive square voltage in SF6, N2 and air are measured respectively, and the surface partial discharge initial voltage (PDIV), discharge current pulse parameters and average discharge time-lag of PEEK in three gases are analyzed in this paper. The results show that, under the same conditions, the PDIV of PEEK is the highest in SF6, followed by N2, and the lowest in air. In SF6, the amplitude of the discharge current pulse is much smaller than that in N2 and air, and the amplitude of the forward discharge pulse is slightly smaller than that of the backward discharge pulse. In N2 and air, the amplitude of the forward discharge pulse is larger than that of the backward discharge pulse, and the difference is larger in N2. The average discharge time-lag is the largest in SF6, followed by N2, and the smallest in air. In SF6, the backward discharge time-lag is larger than the forward discharge time-lag, and the acceleration factor of backward discharge is larger than that of forward discharge. In N2 and air, the time-lag of backward discharge is smaller than that of forward discharge, and the acceleration factor of backward discharge is smaller than that of forward discharge. Based on the existing research, this paper proposes a surface discharge model of PEEK in SF6, compares the differences in the discharge characteristics under different types of gases, and explains the surface discharge mechanism of PEEK in the SF6 gas environment. © 2023 Science Press. All rights reserved.

引用

页码：5260 / 5269

页数：9

共 28 条

[1] WANG H Y, ZHAO Z B, FU P Y, Et al., Insulation performance of polyetheretherketone frame inside press-pack insulated gate bipolar transistors, 2018 IEEE International Power Electronics and Application Conference and Exposition (PEAC), pp. 1-4, (2018)
[2] O'NEAL C B, MCGEE B, MCPHERSON B, Et al., Advanced materials for high temperature, high performance, wide bandgap power modules, Journal of Electronic Materials, 45, 1, pp. 245-254, (2016)
[3] FU P Y, ZHAO Z B, LI X B, Et al., Partial discharge measurement and analysis in PPIs, IET Power Electronics, 12, 1, pp. 138-146, (2019)
[4] FU P Y, ZHAO Z B, CUI X, Et al., Partial discharge measurement and analysis in high voltage IGBT modules under DC voltage, CSEE Journal of Power and Energy Systems, 4, 4, pp. 513-523, (2018)
[5] FU P Y, ZHAO Z B, LI X B, Et al., Surface discharge characteristics and initiation mechanism of PEEK in nitrogen under semi-square voltage, AIP Advances, 8, 7, (2018)
[6] FU P Y, ZHAO Z B, LI X B, Et al., The role of time-lag in the surface discharge inception under positive repetitive pulse voltage, Physics of Plasmas, 25, 9, (2018)
[7] MENG X R, LI X B, LI Y, Et al., Influence of rise time and fall time on surface discharge characteristics of PEEK under positive repetitive square voltage, IEEE Transactions on Dielectrics and Electrical Insulation, 28, 1, pp. 183-191, (2021)
[8] YANG Z D, LI X B, MENG X R, Et al., Influence of frequency on the surface discharge characteristics of PEEK under positive repetitive square voltage, High Voltage, 5, 6, pp. 669-678, (2020)
[9] LI Y, LI X B, MENG W, Et al., Influence of N2 pressure on surface discharge characteristics of PEEK under positive repetitive square voltage, High Voltage, 6, 5, pp. 793-804, (2021)
[10] LI Y, LI X B, ZHAO Z B, Et al., Influence of temperature on surface discharge characteristics of PEEK under positive repetitive square voltage, IEEE Transactions on Dielectrics and Electrical Insulation, 28, 5, pp. 1652-1660, (2021)

← 1 2 3 →