Influence of NiCoCrALY spraying process on oxidation resistance of 8YSZ thermal barrier coatings

被引:0
|
作者
Li, Wen-Sheng [1 ,2 ]
Wang, Yu-Xi [1 ]
机构
[1] School of Materials Science and Engineering, Lanzhou University of Technology, Lanzhou,730050, China
[2] State Key Laboratory of Advanced Processing and Recycling of Nonferrous Metals, Lanzhou University of Technology, Lanzhou,730050, China
来源
Surface Technology | 2019年 / 48卷 / 08期
基金
中国国家自然科学基金;
关键词
Alumina - Aluminum oxide - Ceramic coatings - Chemical analysis - Chromium alloys - Cobalt alloys - Cobalt compounds - Inorganic coatings - Nickel oxide - Oxidation resistance - Plasma jets - Sprayed coatings - Substrates - Surface roughness - Thermal barrier coatings - Thermooxidation;
D O I
10.16490/j.cnki.issn.1001-3660.2019.08.035
中图分类号
学科分类号
摘要
The work aims to improve the high temperature oxidation resistance of thermal barrier coatings. NiCoCrAlY bond coats with different structures were prepared by detonation spraying (DS) and air plasma spraying (APS). Then, 8YSZ ceramic coatings was prepared by APS to analyze the high temperature oxidation resistance of thermal barrier coatings on bond coats with two different structures. The phase composition, microstructure and chemical composition of coatings were analyzed by X-ray diffraction, scanning electronic microscopy and energy disperse spectroscopy. The interfaces between the coatings and substrate and high temperature oxidation resistance of TBCs were investigated. DS-bond coat was dense and uniform and had less internal defects and interfacial pores with substrate, while the APS-bond coat presented more pores and low surface roughness and apparently exhibited a layered structure. A layer of Al2O3-rich oxide was formed on the surface of DS-bond coat after oxidation for 5 hours, while a layer of mix oxides (e.g. NiO, CoO, Cr2O3 and Ni(Cr,Al)2O4) was formed on the surface of APS-bond coat. Additionally, a number of micro cracks and layered oxides were found in the APS-bond coat. The weight gain of DS thermal barrier coating sample was faster than that of the APS sample in the first 5 hours oxidation and then became slowly, while the APS thermal barrier coating sample still showed high oxidation rate. Thermally grown oxide (TGO) of detonation sprayed coating still remained uniform oxide layer after 50 h oxidation. TGO layer closed to bond coat had less oxide defect. The bond coat of detonation sprayed coating has uniform and dense structure, thus preventing the oxidation during spraying and inner-oxidation during heat treatment, and promoting the formation of a dense Al2O3 layer. Finally, the diffusion between oxygen and metal atom is suppressed and the high temperature oxidation resistance of TBCs is improved dramatically. © 2019, Chongqing Wujiu Periodicals Press. All rights reserved.
引用
收藏
页码:263 / 271
相关论文
共 50 条
  • [1] High temperature oxidation resistance of TNM alloy coated with/without 8YSZ/NiCoCrAlY thermal barrier coatings
    Zhang, Yefei
    Jiang, Haitao
    Tian, Shiwei
    Xu, Wei
    Wang, Tianxiang
    Zhang, Siyuan
    Zeng, Shangwu
    Luo, Wei
    Zhang, Yun
    APPLIED SURFACE SCIENCE, 2023, 611
  • [2] Thermal cycling behavior of nanostructured 8YSZ, SZ/8YSZ and 8CSZ/8YSZ thermal barrier coatings fabricated by atmospheric plasma spraying
    Zhou, Feifei
    Wang, You
    Cui, Zhongyuan
    Wang, Liang
    Gou, Junfeng
    Zhang, Qiwen
    Wang, Chaohui
    CERAMICS INTERNATIONAL, 2017, 43 (05) : 4102 - 4111
  • [3] Study on thermal resistance performance of 8YSZ thermal barrier coatings
    Wang, Yuzhang
    Li, Jiali
    Liu, Hongzhao
    Weng, Yiwu
    INTERNATIONAL JOURNAL OF THERMAL SCIENCES, 2017, 122 : 12 - 25
  • [4] Study on the properties of 8YSZ thermal barrier coatings by atmospheric plasma spraying
    Li, J. J.
    Zhang, Y. F.
    Li, Q.
    Hao, Q.
    Ran, X. Y.
    Guo, X. L.
    DIGEST JOURNAL OF NANOMATERIALS AND BIOSTRUCTURES, 2023, 18 (04) : 1275 - 1292
  • [5] Thermal Shock Resistance of APS 8YSZ Thermal Barrier Coatings on Titanium Alloy
    Zeng, Shuibing
    Liu, Yangjia
    Fan, Xizhi
    Huang, Wenzhi
    Gu, Lijian
    Zou, Binglin
    Chen, Xiaolong
    Khan, Zuhair S.
    Zhu, Ling
    Yang, Daowu
    Cao, Xueqiang
    JOURNAL OF THERMAL SPRAY TECHNOLOGY, 2012, 21 (02) : 335 - 343
  • [6] Thermal Shock Resistance of APS 8YSZ Thermal Barrier Coatings on Titanium Alloy
    Shuibing Zeng
    Yangjia Liu
    Xizhi Fan
    Wenzhi Huang
    Lijian Gu
    Binglin Zou
    Xiaolong Chen
    Zuhair S. Khan
    Ling Zhu
    Daowu Yang
    Xueqiang Cao
    Journal of Thermal Spray Technology, 2012, 21 : 335 - 343
  • [7] Optimization of process parameters for thermal shock resistance and thermal barrier effects of 8YSZ thermal barrier coatings through orthogonal test
    Wu, Shuo
    Zhao, Yuantao
    Li, Wenge
    Liu, Weilai
    Wu, Yanpeng
    Liu, Fukang
    AIP ADVANCES, 2021, 11 (06)
  • [8] Isothermal Oxidation Properties of YAG/8YSZ Double Ceramic Thermal Barrier Coatings
    Li Wensheng
    Zhang Yi
    An Guosheng
    Cheng Bo
    Feng Li
    Yang Lexin
    RARE METAL MATERIALS AND ENGINEERING, 2019, 48 (12) : 3961 - 3968
  • [9] Isothermal Oxidation Properties of YAG/8YSZ Double Ceramic Thermal Barrier Coatings
    Li, Wensheng
    Zhang, Yi
    An, Guosheng
    Cheng, Bo
    Feng, Li
    Yang, Lexin
    Xiyou Jinshu Cailiao Yu Gongcheng/Rare Metal Materials and Engineering, 2019, 48 (12): : 3961 - 3968
  • [10] Improved oxidation life of segmented plasma sprayed 8YSZ thermal barrier coatings
    Smialek J.L.
    Journal of Thermal Spray Technology, 2004, 13 (01) : 66 - 75