Design and test of the self-propelled dynamic balance confining pressure water jet drilling

被引：0
|
作者：
Liang C. [1 ,2 ]
Yao N. [2 ]
Yao Y. [1 ,2 ]
Zhang J. [2 ]
Sha C. [2 ]
Li K. [2 ]
机构：
[1] China Coal Research Institute, Beijing
[2] Xi'an Research Institute of China Coal Technology & Engineering Croup Corp, Xi'an
来源：
Meitan Xuebao/Journal of the China Coal Society | 2020年 / 45卷 / 10期
关键词：
Downhole confining pressure; Drilling rate; High pressure nozzle; Self-propelled; Water jet;
D O I：
10.13225/j.cnki.jccs.2019.1079
中图分类号：
学科分类号：
摘要：
Aiming at the requirements of the test on high-pressure water jet drilling in the research of increasing productivity for the equipment with minimum sidetracking in CBM wells, in order to simulate the status of the self-propelled dynamic balance downhole confining pressure water jet to approach more closely the situation of the actual water jet drilling test, the test device for the self-propelled dynamic balance confining pressure drilling was developed. The device includes three parts: dynamic balance force measurement, counter weight and confining pressure tank. It can conduct water jet drilling test for self-propelled force, drilling rate and different combination of nozzles on coal samples with 200 mm in diameter and 300 mm in length in submerged state and within 10 MPa. Then the calibration test of the test device was carried out by using the method of counter weight and interior sealing resistance balance during uniform motion, the relationship between the resistance of the sealing element and the required counter weights under different confining pressure was found. Finally the water jet drilling test was conducted under non-submerged, submerged and confining pressure status by using the simulating test device, the relationship among the jet flow, angle and drilling rate, hole-forming diameter and pressure of drilling with the self-propelled rotary nozzle was obtained. The test results indicated that under the same conditions and the sub-merged status, the drilling rate and the self-propelled force were reduced at certain extent. Under confining pressure status, the self-propelled force, the drilling rate and the hole-forming diameter decreased with the increase of confining pressure, the self-propelled force and the drilling rate decreased sharply after the confining pressure reached 2 MPa. Through the comparison of the test results of three kinds of nozzles, when the rear injection angle was small, the self-propelled force was bigger, when the rotary torque was smaller, it was easy to be clamped, therefore it was suggested to use the scheme with the rear injection angle 40° and increase the rotary torque. At the same time, the difference between the measured flow and the theoretically calculated flow was more than 30%, which indicates throttling occurs in the nozzle. It is suggested to increase the nozzle overflow diameter. © 2020, Editorial Office of Journal of China Coal Society. All right reserved.
引用
收藏
页码：3533 / 3540
页数：7
相关论文
共 18 条
  • [1] DICKINSON W, DYKSTRA H, NEES J M, Et al., The ultrashort radius radial system applied to thermal recovery of heavy oil, (1992)
  • [2] LI Gensheng, HUANG Zhongwei, LI Jingbin, Study of the key techniques in radial jet drilling, Petroleum Drilling Techniques, 45, 2, pp. 1-9, (2017)
  • [3] WANG Bin, LI Gensheng, HUANG Zhongwei, Et al., Hydraulics calculations and field application of radial jet drilling, SPE Drilling & Completion, 31, 1, pp. 71-81, (2016)
  • [4] QIN Yong, YUAN Liang, HU Qianting, Et al., Status and development orientation of coal bed methane exploration and development technology in China, Coal science and Technology, 40, 10, pp. 1-6, (2012)
  • [5] LI Gensheng, HUANG Zhongwei, TIAN Shouceng, Et al., Research and application of water jet technology in well completion and stimulation in china, Petroleum Science, 7, 2, pp. 239-244, (2010)
  • [6] SHEN Chunming, LIN Baiquan, WU Haijin, High-pressure water jet slotting and influence on permeability of coal seams, Journal of China Coal Society, 36, 12, pp. 2058-2063, (2011)
  • [7] LU Yiyu, LIU Yong, XIA Binwei, Et al., The novel technology of drilling arrangement of rock cross-cut coal uncovering basing on theoretical analysis, Journal of China Coal Society, 36, 2, pp. 283-287, (2011)
  • [8] LIU Yong, LU Yiyu, LI Xiaohong, Et al., Application of drilling in roof or floor with high pulse pressure water jet to improve gas drainage, Journal of China Coal Society, 35, 7, pp. 1115-1119, (2010)
  • [9] MU Zhaomin, WANG Hailu, Damage mechanism of coal under high pressure water jeting, Rock and Soil Mechanics, 34, 5, pp. 1515-1520, (2013)
  • [10] MU Chaomin, HAN Jing, Mechanical characteristics of high-pressure water jets impacting on coal, Explosion and Shock Waves, 35, 3, pp. 442-448, (2015)
12