Experimental investigation of reinforced concrete columns with composite spiral stirrups under eccentric loading

被引：0
|
作者：
Li M. [1 ]
Zhou W. [1 ,2 ,3 ]
Liu M. [1 ]
Liu G. [1 ,2 ,3 ]
Zhang S. [4 ]
机构：
[1] School of Civil Engineering, Harbin Institute of Technology, Harbin
[2] Key Lab of Structures Dynamic Behavior and Control (Harbin Institute of Technology), Ministry of Education, Harbin
[3] Key Lab of Smart Prevention and Mitigation of Civil Engineering Disasters (Harbin Institute of Technology), Ministry of Industry and Information Technology, Harbin
[4] 61905 Troop of People's Liberation Army, Shenyang
来源：
Harbin Gongye Daxue Xuebao/Journal of Harbin Institute of Technology | 2019年 / 51卷 / 12期
关键词：
Composite spiral stirrups; Confined reinforced concrete; Ductility performance; Eccentric bearing capacity;
D O I：
10.11918/j.issn.0367-6234.201812034
中图分类号：
学科分类号：
摘要：
The application of composite spiral stirrups confined reinforced concrete columns can improve the core concrete strength and realize high ductility, which can be utilized to design and construct important structures in seismic zones of high intensity. A total of 6 concrete columns confined by composite spiral stirrups were tested under eccentric loading with different stirrup spacing and axial force eccentricities, and the results were compared with other two conventional composite stirrups confined columns under the same condition. The relationships of axial force with lateral deformation, stirrup strain, and compressive strain at the edge of the compression zone were obtained. Failure modes of longitudinal reinforcement yield and concrete crushing of the columns occurred successively under different spacing and eccentricities. Test results indicate that when the spacing is smaller than 80 mm, the composite spiral stirrups confined columns exhibited higher bearing capacity than conventional columns, the strength of the confined concrete is increased, and the defined displacement ductility is improved. Furthermore, the dual-confinement to the concrete consisted of core confinement by spiral stirrups and surrounding confinement by rectangular stirrups had significant effects on failure modes. The failure of the specimen was mainly caused by crushing and spalling of the concrete after buckling of longitudinal reinforcement. It was observed in the tests that the rectangular stirrups continuously provided a superior confinement effect on concrete even after the peak load while the spiral stirrups lost its efficacy. Based on the failure mechanism and the contribution of two different transverse reinforcement, spiral stirrups and rectangular stirrups, a calculation formula for eccentric bearing capacity of composite spiral stirrups confined concrete columns was proposed. © 2019, Editorial Board of Journal of Harbin Institute of Technology. All right reserved.
引用
收藏
页码：113 / 120
页数：7
相关论文
共 15 条
  • [1] Zhang S., Research on mechanical properties of reinforced concrete square columns with circular compound spiral stirrup, (2016)
  • [2] Zhang Q., Jiang W., Yu Q., Et al., Manufacturing technology and engineering application of high-strength continuous compound spiral hoop, Construction Technology, 43, 3, (2014)
  • [3] Richart F.E., Brandtzaeg A., Brown R.L., Failure of plain and spirally reinforced concrete in compression, University of Illinois Bulletin, 26, (1929)
  • [4] Ahmad S.H., Shah S.P., Stress-strain curves of concrete confined by spiral reinforcement, ACI Structural Journal, 79, 6, (1982)
  • [5] Mander J.B., Priestley M.J., Park R., Theoretical stress strain model for confined concrete, Journal of Structural Engineering, 114, 8, (1988)
  • [6] Bing L., Park R., Tanaka H., Stress-strain behavior of high-strength concrete confined by ultra-high-and normal-strength transverse reinforcements, ACI Structural Journal, 98, 3, (2001)
  • [7] William K.L., Warnke E.P., Constitutive model for the triaxial behavior of concrete, Proceedings of International Association for Bridge and Structural Engineering, 19, (1975)
  • [8] West J., Ibrahim A., Hindi R., Analytical compressive stress-strain model for high-strength concrete confined with cross-spirals, Engineering Structures, 113, (2016)
  • [9] Shi Q., Wang N., Tian Y., Et al., Study on stress-strain relationship of high-strength concrete confined with high-strength stirrups under axial compression, Journal of Building Structures, 34, 4, (2013)
  • [10] Zheng W., Hou C., Design method for confined concrete column with different yield strength stirrups, Journal of Building Structures, 37, 12, (2016)
12