Theoretical Strain Analysis of Cutting Part of Hardened Tool

被引：0

作者：

Konyashkin, V. I. ^{[1
]}

机构：

[1] Bryansk State Engn Technol Acad, Bryansk, Russia

来源：

LESNOY ZHURNAL-FORESTRY JOURNAL | 2009年 / 03期

关键词：

stresses; hardening; cutting part; analysis; load;

D O I：

暂无

中图分类号：

S7 [林业];

学科分类号：

0829 ; 0907 ;

摘要：

The dependencies of strains in the hardened cutter are obtained under effect of residual stress and loads from the cutting force on its cutting part.

引用

页码：86 / +

页数：6

共 50 条

[1] Cutting tool wear in the machining of hardened steels Part I: alumina/TiC cutting tool wear
Barry, J
Byrne, G
WEAR, 2001, 247 (02) : 139 - 151
[2] Cutting tool wear in the machining of hardened steels Part II: cubic boron nitride cutting tool wear
Barry, J
Byrne, G
WEAR, 2001, 247 (02) : 152 - 160
[3] Wear development and cutting forces on CBN cutting tool in Hard Part turning of different hardened steels
Sadik, M. Ibrahim
FIFTH CIRP CONFERENCE ON HIGH PERFORMANCE CUTTING 2012, 2012, 1 : 232 - 237
[4] Composition of the Hardened Surface of a Carbide Cutting Tool
Plotnikov S.A.
Cheremisinov P.N.
Kluonis A.S.
Kozlov E.V.
Russian Engineering Research, 2024, 44 (4) : 534 - 536
[5] Tool wear mechanism in continuous cutting of hardened tool steels
Chou, YK
Evans, CJ
WEAR, 1997, 212 (01) : 59 - 65
[6] Tool wear mechanism in continuous cutting of hardened tool steels
Natl Inst of Standards and, Technology, Gaithersburg, United States
Wear, 1 (59-65):
[7] Tool wear mechanism in continuous cutting of hardened tool steels
Natl Inst of Standards and, Technology, Gaithersburg, United States
Wear, 1 ([d]59-65):
[8] Cutting Forces Analysis During High Speed Milling of Hardened Tool Steel
Abdulgadir, Mustafa M.
MODERN METHODS OF CONSTRUCTION DESIGN, 2014, : 549 - 555
[9] Wear mechanism of cBN tool in cutting of hardened steel
Egawa, Tsuneo
Ichikizaki, Tetsuo
Kuroda, Motofumi
Hiasa, Yukio
Tsukamoto, Hidehiko
Seimitsu Kogaku Kaishi/Journal of the Japan Society for Precision Engineering, 1995, 61 (06): : 809 - 813
[10] Influence of cutting tool overhangs at machining of hardened steels
Faculty of Mechanical Engeniering, Brno University of Technology, Technická 2896/2, Brno
616 69, Czech Republic
Manuf. Technol., 2 (188-191):

← 1 2 3 4 5 →