PHASE-TRANSFORMATION IN AN FE-10.1AL-28.6MN-O.46C ALLOY

被引:36
|
作者
WU, CC [1 ]
CHOU, JS [1 ]
LIU, TF [1 ]
机构
[1] NATL CHIAO TUNG UNIV,INST MAT SCI & ENGN,HSINCHU 30049,TAIWAN
关键词
D O I
10.1007/BF02664992
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The microstructure of an (alpha + gamma) duplex Fe-10.1A1-28.6Mn-0.46C alloy has been investigated by means of optical microscopy and transmission electron microscopy (TEM). In the as-quenched condition, extremely fine D0(3) particles could be observed within the ferrite phase. During the early stage of isothermal aging at 550-degrees-C, the D0(3) particles grew rapidly, especially the D0(3) particles in the vicinity of the alpha/gamma grain boundary. After prolonged aging at 550-degrees-C, coarse K-phase (Fe, Mn)3AlC precipitates began to appear at the regions contiguous to the D0(3) particles, and beta-Mn precipitates occurred on the alpha/gamma and alpha/alpha grain boundaries. Subsequently, the grain boundary beta-Mn precipitates grew into the adjacent austenite grains accompanied by a gamma --> alpha + beta-Mn transition. When the alloy was aged at 650-degrees-C for short times, coarse K-phase precipitates were formed on the alpha/gamma grain boundary. With increasing the aging time, the alpha/gamma grain boundary migrated into the adjacent austenite grain, owing to the heterogeneous precipitation of the Mn-enriched K phase on the grain boundary. However, the alpha/gamma grain boundary migrated into the adjacent ferrite grain, even though coarse K-phase precipitates were also formed on the alpha/gamma grain boundary in the specimen aged at 750-degrees-C.
引用
收藏
页码:2265 / 2276
页数:12
相关论文
共 50 条
  • [1] PHASE-TRANSFORMATION IN A DUPLEX FE-MN-AL-C ALLOY
    HWANG, KH
    WAN, CM
    BYRNE, JG
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1991, 132 : 161 - 169
  • [2] PHASE-TRANSFORMATION OF MN-AL ALLOY POWDERS
    HUANG, JH
    KUO, PC
    SCRIPTA METALLURGICA ET MATERIALIA, 1993, 28 (01): : 133 - 138
  • [3] PHASE-TRANSFORMATION IN AN FE-9.0AL-29.5MN-1.2SI ALLOY
    LIU, TF
    UEN, GC
    CHAO, CY
    LIN, YL
    WU, CC
    METALLURGICAL TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1991, 22 (06): : 1407 - 1415
  • [4] PHASE-TRANSFORMATION STUDIES ON MN-AL-C ALLOY, BY DSC AND ELECTRICAL-RESISTIVITY MEASUREMENTS
    RAO, V
    MITRA, A
    JOURNAL OF THERMAL ANALYSIS, 1995, 44 (02): : 375 - 384
  • [5] Phase transformation of high temperature on Fe-Al-Mn-Cr-C alloy
    Liu, Chung-Ming
    Cheng, Hsin-Chung
    Chao, Chih-Yeh
    Ou, Keng-Liang
    JOURNAL OF ALLOYS AND COMPOUNDS, 2009, 488 (01) : 52 - 56
  • [6] PHASE-TRANSFORMATION IN POWDER FE-MN ALLOYS
    VOLYNOVA, TF
    MEDOV, IB
    METAL SCIENCE AND HEAT TREATMENT, 1986, 28 (1-2) : 107 - 111
  • [7] MICROSTRUCTURAL DEVELOPMENT IN THE OXIDATION-INDUCED PHASE-TRANSFORMATION OF FE-AL-CR-MN-C ALLOYS
    DUH, JG
    LEE, JW
    WANG, CJ
    JOURNAL OF MATERIALS SCIENCE, 1988, 23 (07) : 2649 - 2660
  • [8] Observing massive phase transformation in a Fe-Mn-Al alloy
    Cheng, Wei-Chun
    Lai, Chih-Kang
    SCRIPTA MATERIALIA, 2006, 55 (09) : 783 - 786
  • [9] STRUCTURAL DISORDER AND PHASE-TRANSFORMATION IN FE, MG AND MN FLUOSILICATES
    JEHANNO, G
    VARRET, F
    ACTA CRYSTALLOGRAPHICA SECTION A, 1975, 31 (NOV1): : 857 - 858
  • [10] CRYSTALLOGRAPHIC PHASE-TRANSFORMATION IN MN0.9FE0.1AS
    SELTE, K
    KJEKSHUS, A
    ANDRESEN, AF
    ACTA CHEMICA SCANDINAVICA, 1973, 27 (09): : 3607 - 3608