Enhancing the thermal stability of natural rubber/recycled ethylene-propylene-diene rubber blends by means of introducing pre-vulcanised ethylene-propylene-diene rubber and electron beam irradiation

被引:18
|
作者
Nabil, H. [1 ]
Ismail, H. [1 ]
机构
[1] Univ Sains Malaysia, Sch Mat & Mineral Resources Engn, Nibong Tebal 14300, Penang, Malaysia
关键词
Natural rubber; Recycled ethylene-propylene-diene rubber; Electron beam irradiation; Thermal stability; Vulcanisation; CROSS-LINKING; CARBON-BLACK; MECHANICAL-PROPERTIES; MONOMER; DEGRADATION; POLYETHYLENE; COMPOUND; KINETICS; SYSTEMS; POWDER;
D O I
10.1016/j.matdes.2013.12.020
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Most rubber materials are subjected to oxidation. The rate of oxidation depends on the type of rubber, processing method, and end-use conditions. The oxidation of rubber can result in the loss of physical properties, such as tensile strength, elongation, and flexibility. Hence, the service life is determined by oxidation stability. Thermal properties are relevant to the potential use of polymeric materials in many consumer oriented applications. Thermo-oxidative ageing and thermogravimetric analysis (TGA) have been proven to be successful techniques in determining the thermal stability of polymers and polymer blends. In this article, preparation of a series of natural rubber/recycled ethylene-propylene-diene rubber (NR/R-EPDM) blends is described. Processing of the blends, by means of introducing pre-vulcanised EPDM and electron beam (EB) irradiation, was carried out. Two thermal analysis methods, namely thermo-oxidative ageing and thermogravimetric analysis, were conducted. The results indicated that pre-vulcanising EPDM for 1.45min (ts - 2) is sufficient to gain the optimum retained tensile and elongation at break. It was simultaneously observed that the introduction of pre-vulcanised EPDM increased decomposition temperature and activation energy by showing optimum values at a pre-vulcanising time of 3.45 min (ts). In the latter study, the retained properties increased after EB irradiation. The results can be verified by the thermal decomposition temperature and their activation energy. The obtained TG profiles and the calculated kinetic parameters indicated that introducing EB irradiation into the blends enhanced their thermal stability. The thermal stability of the blends, processed by these two means, is significantly enhanced; irrespective of pre-vulcanising time or irradiation dose. (C) 2013 Elsevier Ltd. All rights reserved.
引用
收藏
页码:1057 / 1067
页数:11
相关论文
共 50 条
  • [21] Preparation and properties of ethylene-propylene-diene rubber/organomontmorillonite nanocomposites
    Li, W
    Huang, YD
    Ahmadi, SJ
    JOURNAL OF APPLIED POLYMER SCIENCE, 2004, 94 (02) : 440 - 445
  • [22] IMPACT STRENGTH OF REACTIVELY EXTRUDED POLYSTYRENE ETHYLENE-PROPYLENE-DIENE RUBBER BLENDS
    CREVECOEUR, JJ
    NELISSEN, L
    VANDERSANDEN, MCM
    LEMSTRA, PJ
    MENCER, HJ
    HOGT, AH
    POLYMER, 1995, 36 (04) : 753 - 757
  • [23] SOLUBILITY AND DIFFUSION OF RUBBER ACCELERATORS IN ETHYLENE-PROPYLENE-DIENE ELASTOMER
    PETROVA, TF
    LAPSHOVA, AA
    DONTSOV, AA
    CHALYKH, AY
    BELYATSKAYA, IA
    VYSOKOMOLEKULYARNYE SOEDINENIYA SERIYA B, 1986, 28 (02): : 125 - 128
  • [24] Artificial weathering of ethylene-propylene-diene monomer (EPDM) rubber
    School of Materials Science and Engineering, University of Science and Technology Beijing, Beijing 100083, China
    不详
    Beijing Keji Daxue Xuebao, 2008, 12 (1422-1427):
  • [25] Thermal and mechanical properties of silicon rubber/cis-polybutadiene rubber/ethylene-propylene-diene monomer blends
    Wu, Weili
    Chen, Dajun
    Journal of Applied Polymer Science, 2006, 101 (06): : 4462 - 4467
  • [26] Thermal and mechanical properties of silicon rubber/cis-polybutadiene rubber/ethylene-propylene-diene monomer blends
    Wu, Weili
    Chen, Dajun
    JOURNAL OF APPLIED POLYMER SCIENCE, 2006, 101 (06) : 4462 - 4467
  • [27] Blending of Natural Rubber/Recycled Ethylene-Propylene-Diene Monomer: Cure Behaviors and Mechanical Properties
    Hayeemasae, Nabil
    Ismail, Hanafi
    Azura, A. R.
    POLYMER-PLASTICS TECHNOLOGY AND ENGINEERING, 2013, 52 (05) : 501 - 509
  • [28] Enhancing the thermal stability of natural rubber/recycled ethylene propylene diene rubber blends through the use of bio-compatibilizers
    Hayeemasae, Nabil
    Ismail, Hanafi
    JOURNAL OF VINYL & ADDITIVE TECHNOLOGY, 2019, 25 : E155 - E165
  • [29] Preparation and characterization of ethylene-propylene-diene monomer rubber/metal hydroxide composites by electron beam irradiation
    Kim, Jeong-In
    Lee, Byoung-Min
    Kim, Hyun-Rae
    Park, Jong-Seok
    Jung, Seung-Tae
    Nho, Young-Chang
    Kim, Jaewoo
    Choi, Jae-Hak
    POLYMER ENGINEERING AND SCIENCE, 2024, 64 (03): : 1454 - 1461
  • [30] Dynamic Mechanical Analysis of Ethylene-Propylene-Diene Monomer Rubber and Styrene-Butadiene Rubber Blends
    Nair, T. Muraleedharan
    Kumaran, M. G.
    Unnikrishnan, G.
    Piiai, V. B.
    JOURNAL OF APPLIED POLYMER SCIENCE, 2009, 112 (01) : 72 - 81