Properties of electrodeposited Co-Mn films: Influence of deposition parameters

被引:10
|
作者
Karpuz, Ali [1 ]
Kockar, Hakan [2 ]
Alper, Mursel [3 ]
机构
[1] Karamanoglu Mehmetbey Univ, Dept Phys, Kamil Ozdag Sci Fac, Karaman, Turkey
[2] Balikesir Univ, Dept Phys, Sci & Literature Fac, Balikesir, Turkey
[3] Uludag Univ, Dept Phys, Sci & Literature Fac, Bursa, Turkey
关键词
Co-Mn alloys; Electrodeposition; Structural characterization; Magnetic propertiesa; MAGNETIC-PROPERTIES; NI-CO; INPLANE ANISOTROPY; ALLOYS; GROWTH; ELECTROLYTES; PERFORMANCE; POTENTIALS; THICKNESS; ROTATION;
D O I
10.1016/j.apsusc.2015.08.179
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Co-Mn films were produced with electrodeposition considering the deposition parameters of electrolyte pH value, Mn concentration of the electrolyte and film thickness. The effect of each parameter on the structural, magnetic and magnetoresistance properties of the films was studied, separately. X-ray diffraction measurement showed that the films have hexagonal close packed structure. For the films deposited at different pH values, the surface morphologies with different-sized globular granules were observed whereas the morphology covered by uniformly distributed nanoscale grains was detected for the surfaces of all films produced from electrolytes with different Mn concentrations. Also, the ribbed surfaces for 6 mu m and 4 mu m, and the nano-sized acicular surface morphologies for 2 mu m were observed. To the results of magnetic measurements, the saturation magnetization was found to be 1230 emu/cm(3) for all films deposited at different electrolyte pHs. The highest remanent magnetization value was obtained to be 882 emu/cm(3) for the film produced from the electrolyte containing 0.06 M Mn concentration. The coercivity, H-c, values decreased from 147 Oe to 43 Oe when the electrolyte pH decreased from 4.7 to 2.6. And, the Hc continued to decrease from 45 Oe to 31 Oe when the Mn concentration increased from 0.02 M to 0.06 M, and from 27 Oe to 22 Oe when the film thickness decreased from 6 pin to 2 mu m. It is seen that the Hc was immensely affected by the deposition parameters applied during the film production. The Co-Mn films with low Hc were achieved using relatively low electrolyte pH, high Mn concentration of electrolyte and low film thickness, respectively. Also, influence of the deposition parameters affect Hc is in order of the electrolyte pH, the Mn concentration in the electrolyte and the film thickness (from high to low influence). As it is observed that the magnetic properties are sensible to the deposition parameters and the Co-Mn films may have the potential applications in magnetic recording and sensors technologies. (C) 2015 Elsevier B.V. All rights reserved.
引用
收藏
页码:605 / 611
页数:7
相关论文
共 50 条
  • [11] INTERDIFFUSION IN CO-MN ALLOYS
    IIJIMA, Y
    TAGUCHI, O
    HIRANO, KI
    METALLURGICAL TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1977, 8 (06): : 991 - 995
  • [12] Preparation and properties characterization of Co-Mn doped carbon aerogels
    Zang J.
    Ni X.
    Wang D.
    Cao M.
    Chi X.
    Cheng W.
    Han G.
    Fuhe Cailiao Xuebao/Acta Materiae Compositae Sinica, 2019, 36 (09): : 2196 - 2203
  • [13] Microstructure, magnetic and magneto-optical properties of chemical synthesized Co-Mn ferrite nanocrystalline films
    Yan, CH
    Zhou, B
    Chen, FX
    Jia, JT
    Liao, CS
    Chen, LY
    Zhao, HB
    JOURNAL OF RARE EARTHS, 2000, 18 (03) : 118 - 123
  • [14] Influence of deposition parameters on the electrodeposited ternary CoFeCu coatings
    Fortas, G.
    Ouir, S.
    Manseri, A.
    Djerir, W.
    Smaili, F.
    Gabouze, N.
    Haine, N.
    JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2024, 35 (21)
  • [15] Influence of deposition potential on the electrodeposited Ternary CoFeCu films
    Hakan Kockar
    Ercument Ozergin
    Oznur Karaagac
    Mursel Alper
    Journal of Materials Science: Materials in Electronics, 2013, 24 : 2562 - 2567
  • [16] Influence of deposition potential on the electrodeposited Ternary CoFeCu films
    Kockar, Hakan
    Ozergin, Ercument
    Karaagac, Oznur
    Alper, Mursel
    JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2013, 24 (07) : 2562 - 2567
  • [17] Influence of the deposition parameters on the properties of orthorhombic SnS films by chemical bath deposition
    Gao, Chao
    Shen, Honglie
    THIN SOLID FILMS, 2012, 520 (09) : 3523 - 3527
  • [18] Influence of (Co-Mn) co-doping on the microstructures, optical properties of sol-gel derived ZnO nanoparticles
    Neena, D.
    Shah, A. H.
    Deshmukh, K.
    Ahmad, H.
    Fu, D. J.
    Kondamareddy, K. K.
    Kumar, P.
    Dwivedi, R. K.
    Sing, V.
    EUROPEAN PHYSICAL JOURNAL D, 2016, 70 (03):
  • [19] Influence of the deposition temperature on the properties of electrodeposited nickel hydroxide films: A study performed by EIS
    Aguilera, L.
    Leyet, Y.
    Perez de la Cruz, J.
    Passos, R. R.
    Pocrifka, L. A.
    MATERIALS SCIENCE AND ENGINEERING B-ADVANCED FUNCTIONAL SOLID-STATE MATERIALS, 2018, 238 : 1 - 6
  • [20] The influence of deposition process parameters on protective properties of silane films
    Owczarek, Edyta
    OCHRONA PRZED KOROZJA, 2020, 63 (01): : 8 - 11